Home/About/Factory Tour
About · Factory Tour

Factory Tour

Most factories do not show the floor. This is ours, room by room — from the imaging line to the bay where boards get tested, with what actually runs in each one.

Engineers reviewing a stack-up on the factory floor

Walkthrough

Five rooms, and what leaves each one.

Inner-layer imaging line at HSX CIRCUIT
01

The PCB main line

Imaging, etching, lamination, drilling and plating all run in this hall. Nothing is subcontracted, which is why a hold on one panel is visible here rather than discovered after a truck ride.

  • Laser direct imaging on inner layers
  • Sequential lamination presses, multi-cycle capable
  • Mechanical drilling from 0.15 mm, laser from 0.1 mm
  • Panel plating with copper thickness measured per lot
Second PCB production hall with plating and inspection stations
02

Inner layer to finished surface

The second hall carries the work between lamination cycles — AOI on every inner layer, registration checks after each press, and the finish lines that put ENIG or immersion silver on the copper.

  • Inner-layer AOI before every lamination cycle
  • Register and dimensional check after pressing
  • ENIG, HASL-LF, OSP, immersion silver and tin
  • Controlled impedance measured on panel coupons
SMT assembly line at HSX CIRCUIT
03

The assembly floor

SMT, through-hole, BGA rework and box build share this floor, which is what makes mixed-technology orders practical instead of a coordination exercise between three suppliers.

  • SMT with SPI before placement
  • Through-hole, selective and wave solder
  • BGA inspection by X-ray, not by eye
  • Box build and final test on the same site
Automated optical inspection station
04

The inspection bay

Every panel passes through here before packing. The gates are the ones described on the testing page, and a panel that fails one does not continue with a note attached.

  • AOI on every layer of every panel
  • 100% electrical test, flying probe or fixture
  • X-ray for via fill and registration
  • Cross-section on sample coupons to IPC-A-600
CAM engineers reviewing designs in parallel
05

The CAM room

Eighty engineers reviewing designs in parallel, which is the reason a difficult board does not wait behind an easy one. The DFM note you receive comes from the person who opened your files.

  • 80+ CAM engineers, parallel review
  • 6,000+ unique designs a month
  • Quote and DFM note in the same reply
  • Direct engineer contact during the build

Process detail

The machines behind those five areas.

Visit Us

Three steps to a walkthrough.

01

Send a date
Two or three working days to choose from, through the contact page or WhatsApp. Mornings are quieter on the floor.

02

We confirm access
You get a named host and the rooms we can open, which depends on what is running and who else is under NDA that week.

03

On the day
Imaging to inspection, with the engineers who run each stage. Bring a stack-up and it becomes a working session rather than a tour.

See the line before the purchase order.

A walkthrough takes about an hour, and the engineer who would review your files is usually in the room. Quote in 24 hours. Every build runs to IPC Class 2 standard, Class 3 on request.

Get a Quote