Backdrilling: Stub Length and Depth Control | HSX CIRCUIT
A residual stub notches the channel at 36 GHz per millimetre on FR-4, so drill depth is a channel-budget decision before it is a process one.
Read articleNine notes from the CAM team, each on a number that decides a design rather than on a topic that fills a page. Where a limit is ours, it is published as a limit; where a figure is an industry window, it is labelled as one.
A residual stub notches the channel at 36 GHz per millimetre on FR-4, so drill depth is a channel-budget decision before it is a process one.
Read articleAt 3 oz the etchant travels sideways through 105 µm of copper, so the minimum space opens to 0.20 mm and the trace section becomes a trapezoid.
Read articleTwo resin systems through one press cycle, a 190 °C compromise profile, and why desmear behaves differently on each plastic.
Read articleThe dielectric sets the thermal limit, not the aluminium: about 0.050 °C/W at 100 µm and 2 W/m·K under a 10 cm² source.
Read articleThree configurations, five cost drivers, and the interconnect count that decides whether the rigid premium comes back.
Read articleAlumina at 20–24 W/m·K and AlN at 170 against 0.2–0.3 for FR-4, plus the crossover arithmetic that decides which one ships.
Read articleWhat each BGA pitch band demands in via type, line width and stack-up, from 1.0 mm down to 0.35 mm.
Read articleFour tolerances, four sensitivities, and why the root-sum-square lands at 7.1% while the worst case reaches 12%.
Read articleSix finishes on flatness, shelf life and cost, and the two questions that remove four of them immediately.
Read articleSend the Gerbers and the stack-up. Quote in 24 hours, with the limit that applies to your design named in it. Every build runs to IPC Class 2 standard, Class 3 on request.